Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volvo V40FACTORY OEM SERVICE PROCEDURE
Guard Lock And Alarm (GLA) DTCS
GUARD LOCK AND ALARM (GLA) - DTC INDEX
| DTC | Description |
|---|---|
| GLA-113 | Fault in control module. Not programmed |
| GLA-114 | Control module. Fault in EEPROM |
| GLA-311 | Siren. Faulty signal. Intermittent fault |
| GLA-311 | Siren. Faulty signal. Permanent fault |
| GLA-312 | Siren. Internal battery fault. Intermittent fault |
| GLA-312 | Siren. Internal battery fault. Permanent fault |
| GLA-321 | Siren. Fault in power supply |
| GLA-415 | Ultrasonic sensor. Faulty signal. Intermittent fault |
| GLA-415 | Ultrasonic sensor. Faulty signal. Permanent fault |
| GLA-416 | Ultrasonic sensor. Internal fault. Intermittent fault |
| GLA-416 | Ultrasonic sensor. Internal fault. Permanent fault |
| GLA-421 | Glass breakage sensor. Faulty signal. Intermittent fault |
| GLA-421 | Glass breakage sensor. Faulty signal. Permanent fault |
| GLA-422 | Glass breakage sensor. Internal fault. Intermittent fault |
| GLA-422 | Glass breakage sensor. Internal fault. Permanent fault |
| GLA-432 | Tilt sensor. Internal fault. Intermittent fault |
| GLA-432 | Tilt sensor. Internal fault. Permanent fault |
| GLA-455 | IMMO-VGLA code. Signal too low. Intermittent fault |
| GLA-455 | IMMO-VGLA code. Signal too low. Permanent fault |
| GLA-456 | SRS signal. Signal too low. Intermittent fault |
| GLA-456 | SRS signal. Signal too low. Permanent fault |
| GLA-511 | Control switch. Signal too low |
| GLA-512 | Control switch. Signal too low |
| GLA-521 | Central locking switch. Signal too low |
| GLA-526 | Central locking switch. Signal too low |
| GLA-531 | Interior lighting. Signal too high |
| GLA-541 | Ignition switch. Signal too low |
| GLA-551 | Childlock. Signal too low |
| GLA-552 | Childlock switch, locking signal. Signal too low |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
