Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volvo V40FACTORY OEM SERVICE PROCEDURE
Activating components/functions
HINT: Activate components/functions by clicking on the symbol for VCT2000.
| No. | Component | Function |
|---|---|---|
| 1 | FUEL PUMP | The fuel pump (FP) is activated for 4 seconds. The fuel pump (FP) runs also when other components are activated |
| 2 | EVAP valve | The canister purge (CP) valve is activated once for 4 seconds. A clicking noise is heard from the valve. |
| 3 | TC CONTROL VALVE | The turbocharger (TC) control valve is activated once for 4 seconds A clicking noise is heard from the valve. |
| 4 | ENG. FAN. LO-SPD | The engine cooling fan (FC) low-speed, the fan runs for 3 seconds. The engine cooling fan (FC) can be heard clearly. |
| 5 | ENG. FAN. HI-SPD | Engine cooling fan (FC) high-speed, the fan runs for 3 seconds The engine cooling fan (FC) can be heard clearly. |
| 6 | A/C CONDS FAN | Air conditioning (A/C) condenser cooling fan, the fan runs for 3 seconds. The engine cooling fan (FC) can be heard clearly. |
| 7 | A/C RELAY | The air conditioning (A/C) relay, the relay is activated once for 4 seconds. A clicking noise is heard from the compressor clutch. |
| 8 | INJECTOR 1 | Injector 1, the injector is open 1.5 ms, closed 498.5 ms, open 1.5 ms and so on in total 10 seconds. A ticking noise is heard from the injector. |
| 9 | INJECTOR 2 | Injector 2, the injector is open 1.5 ms, closed 498.5 ms, open 1.5 ms and so on in total 10 seconds. A ticking noise is heard from the injector. |
| 10 | INJECTOR 3 | Injector 3, the injector is open 1.5 ms, closed 498.5 ms, open 1.5 ms and so on in total 10 seconds. A ticking noise is heard from the injector. |
| 11 | INJECTOR 4 | Injector 4, the injector is open 1.5 ms, closed 498.5 ms, open 1.5 ms and so on in total 10 seconds. A ticking noise is heard from the injector. |
| 12 | IAC VALVE | The idle air control (IAC) valve is activated with short pulses for 0.5 second. A buzzing noise is heard from the valve. |
| 13 | MIL | Malfunction indicator lamp (MIL), malfunction indicator lamp (MIL) goes out for 4 seconds then lights up again. |
| 14 | FRONT HO2S | Sensor preheating, front heated oxygen sensor (HO2S), the heating is on for 1 second. Use a voltmeter to check signal. |
| 15 | REAR λHO2S | Sensor preheating, rear heated oxygen sensor (HO2S), the heating is on for 1 second. Use a voltmeter to check signal. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.