2000 Volvo V40FACTORY OEM SERVICE PROCEDURE

Checking brake discs: Notes

Check the brake disc.

Turn or replace the brake disc if necessary. See Front brake disc replacement for the front brake discs. For the rear brake discs, see Replacement of rear brake disc .

Fig 1: Identifying Brake Pads In Rear Brake Caliper
GLL116151Courtesy of VOLVO CARS OF NORTH AMERICA.

Did the brake disc need to be turned or replaced? 

  • YES 

    Refer to Verification 

  • NO 

    FAULT NOT FOUND:  Troubleshooting has been completed.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.