Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE
Front Measurement
- Lift up front end of vehicle under the control arms as close to the ball joints as possible. See Fig 1 . Check for play or looseness in the steering gear or tie rods, the wheel bearings, the upper spring strut mountings and control arm ball joints and bushings. If there is play in any of the above components, it must be corrected before an alignment can be performed.
- Set up and calibrate test equipment according to manufacturer's instructions. Position the turntables under the front wheels. Use turntables which take up lateral movement. The car must stand level when the front wheels are on the turntables. Bounce the front suspension heavily a few times when the car has sunk onto the turntables.
- Check the camber angle on both sides. Check measurement against specification. See WHEEL ALIGNMENT SPECIFICATIONSΒ . If the front camber angle is not within specifications, adjust as needed. See CAMBER ADJUSTMENTΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
