2000 Volvo S80 BaseFACTORY OEM SERVICE PROCEDURE

Visual check

Fig 1: Identifying Warning Light
GLL104247Courtesy of VOLVO CARS OF NORTH AMERICA.

Turn on the ignition.

Wait five seconds and until the symbol for the brakes on the dashboard has gone out.

In the event of a fault (the symbol is lit).

Check that the connector is connected.

Chapter Navigation
Return to Chapter: Installation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.