Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic trouble code (DTC) information
Condition
The control modules exchange information over a network via a standardized serial communication interface - CAN (Controller Area Network). Control modules transmit and receive information. Diagnostic trouble code (DTC) ABS-0091 is stored if the ABS control module registers that communication is missing or subject to interference.
Substitute Value
- CAN communication blocked.
- Anti-spin function blocked.
Possible Source
- Contact resistance in terminals.
- Open-circuit in one or both signal cables.
- Short-circuit to ground, voltage or each other in one or both signal cables.
- Interference in wiring.
- Defective control module.
Fault symptom[s]
- ABS warning lamp lit.
- Anti-spin warning lamp lit.
- Brake circuit not functioning, warning lamp lit.
- Anti-spin does not function.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
