Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volvo S70 Base, StandardFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||||||||
|---|---|---|---|---|---|---|---|---|---|
| Clutch Master Cylinder Bolt | 18 (25) | ||||||||
| Engine Mount-To-Transaxle Bolt | 37 (50) | ||||||||
| Engine-To-Transaxle Bolt | 37 (50) | ||||||||
| Hub Center Nut | (1) 89 (120) | ||||||||
| Link Arm-To-Anti-Roll Bar Nut | 37 (50) | ||||||||
| Pressure Plate-To-Flywheel Bolt | 18 (25) | ||||||||
| Rear Engine Splash Guard Nut | 37 (50) | ||||||||
| Steady Bar Bracket-To-Transaxle Bolt | (2) 26 (35) | ||||||||
| Steering Gear Nut | 37 (50) | ||||||||
| Subframe Bracket Bolt | 37 (50) | ||||||||
| Subframe & Support Plate Bolt | (3) 77 (105) | ||||||||
| Torque Control Arm Bolt | (2) 26 (35) | ||||||||
| Torque Rod Mounting Bolt | (4) 26 (35) | ||||||||
| Transaxle-To-Engine Bolt | 37 (50) | ||||||||
| Wheel Lug Nut | 81 (110) | ||||||||
| INCH lbs. (N.m) | |||||||||
| Clutch Release Cylinder Bolt | 89 (10) | ||||||||
|
|||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.