Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volvo S70 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Miscellaneous
MISCELLANEOUS
| Component | Component Location |
|---|---|
| Alarm Horn | On rear center of engine compartment. |
| Alarm Siren | On right side of engine compartment. |
| Amplifier | On left rear corner of luggage compartment. |
| Antenna Booster (C70) | On right rear corner of luggage compartment. |
| Antenna Booster (S70) | On left "C" pillar. |
| Antenna Booster (V70) | On left rear side of cargo compartment. |
| Blower Fan Resistor | On right side of HVAC housing. |
| Control Module Box | On right side of engine compartment. See Figure . |
| Data Link Connector (DLC) | On center console, near shift lever. See Figure . |
| Distributor | On rear of engine. See Figure . |
| Engine Coolant Heater | On left front of engine compartment. |
| Indicator LED Alarm/Electronic Immobilizer | On top center of dash, integral with ECC Sun Sensor. |
| Potentiometer Lifter | At base of left side of soft top cover panel assembly. |
| Rollover Bar (Right/Left) | Behind respective rear seat. |
| RTI TMC/FM Receiver | Behind right side of dash. |
| Seat Belt Tensioner Ignitor (4) | Integrated into respective seat belt reel assembly. |
| Soft Top Potentiometer | At base of soft top mechanism, above right rear inner fender. |
| TV Receiver | Behind center of dash. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.