Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volvo S70 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Connectors
CONNECTORS
| Component | Component Location |
|---|---|
| 24/1A (Green, 12 Pin) | Behind dash, left of steering column. |
| 24/1E (White, 12 Pin) | Behind right side of dash. |
| 24/2A (Green, 12 Pin) | Behind dash, left of steering column. |
| 24/3B (Light Blue, 12 Pin) | Behind dash, left of steering column. |
| 24/4B (Light Blue, 18 Pin) | Behind right side of dash. |
| 24/7A (Green, 24 Pin) | Under center console. |
| 24/7B (Natural, 10 Pin) | Under center console. |
| 24/9A (Green, 12 Pin) | Center of left "A" pillar. |
| 24/14 (Red, 18 Pin) | Behind left side of dash. |
| 24/15 (Light Gray, 10 Pin) | Right front of engine compartment. |
| 24/17 (Natural, 11 Pin) | Left "B" pillar. |
| 24/18 (Natural, 11 Pin) | Right "B" pillar. |
| 24/19 (C70) (Yellow, 4 Pin) | Below right rear seat. |
| 24/19 (S70, V70) (Yellow, 4 Pin) | Near right rear shock tower. |
| 24/20 (Green, 12 Pin) | Center of right "A" pillar. |
| 24/25 (Natural, 11 Pin) | Left rear corner of vehicle. |
| 24/43 (Black, 8 Pin) | Left front of engine compartment. |
| 24/44 (Gray, 2 Pin) | Left side of engine compartment. |
| 24/50 (Black, 24 Pin) | Left "A" pillar. |
| 24/55 (White, 11 Pin) | Below right rear seat. |
| 24/60 (Black, 24 Pin) | Right "A" pillar. |
| 24/63 (Light Gray, 14 Pin) | Behind right side of dash. |
| 24/67 (Natural, 6 Pin) | Left rear of luggage compartment. |
| 24/71 (Gray, 6 Pin) | Left front of engine compartment. |
| 24/91 (Black, 2 Pin) | Below right rear seat. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.