Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
On-Board Diagnostics: Notes
This system has complete self-diagnostic capabilities. This systems uses a single Powertrain Control Module (PCM) that receives input from engine monitoring sensors. The PCM uses these input signals to control air/fuel mixture for emission control, fuel economy and good driveability.
Signals from various sensors are monitored continuously. If certain signals are lost or become faulty, PCM will adopt fixed substitute values (limp-home mode) to enable vehicle to be driven for certain failures. Substitute values can be adopted for Engine Coolant Temperature (ECT) sensor signal, Throttle Position (TP) sensor signal, Mass Airflow (MAF) sensor signal, and oxygen sensor (HO2S) signal.
Faults are recorded in PCM memory in the form of Diagnostic Trouble Codes (DTCs). Codes can be displayed using a generic scan tester connected to On-Board Diagnostics II (OBD-II) Data Link Connector (DLC).
PCM stores Diagnostic Trouble Codes (DTCs) differently in accordance with a predetermined pattern. An emission related fault must be present for a predetermined number of intervals before PCM permanently stores a DTC and illuminates MIL. If fault is cleared before a specified interval has passed, DTC is erased from memory. There are 3 main types of intervals:
- Trip
All diagnostic functions have been performed. - Running Cycle
Fuel trim (closed loop) has been initiated. - Time
Time in seconds.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
