Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fault Conditions
Control modules communicate with each other in a network via a standardized serial communication method - CAN (Controller Area Network). ECM has registered a fault in the communication on the CAN network. ECM-901A is stored in ECM.
Substitute values are:
- Accelerator pedal is ignored when braking
- Cruise control cannot be activated
- RPM is limited using fuel shut off. Maximum permitted engine speed depends on accelerator pedal position.
- Throttle unit follows pulse width modulation accelerator pedal signal directly and control signal via CAN is ignored.
Electronic Throttle System (ETS) warning lamp is lit while ECM-901A is set. DTC can also cause uneven idle and jerking during engine braking.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
