Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Volvo S40FACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS Control Module | In right front corner of engine compartment. See Figure. |
| A/C Compressor Control Module | Behind right center of dash. See Figure. |
| A/C Control Module | Integral with A/C controls, in center of dash. |
| Automatic Transmission Control Module (TCU) | Behind lower center of dash. See Figure. |
| Central Electric Module (CEM) | Behind left end of dash. See Figure. |
| Cruise Control Module | Behind right center of dash. See Figure. |
| DSA Control Module | Behind right end of dash. See Figure. |
| ECC Blower Motor Speed Regulator | Under right side of dash, in HVAC housing. |
| ECC Control Module | Integral with A/C controls, in center of dash. |
| Engine Control Module (ECM) | Behind lower center of dash. See Figure. |
| Ignition Warning Control Module | Behind lower left center of dash. See Figure. |
| Immobilizer Control Module | Behind left end of dash. See Figure. |
| Power Sun Roof Control Module | Above headliner, at front center of roof. |
| SRS Control Module | Below rear of center console, between front seats. See Figure. |
| VGLA Control Module | Behind lower center of dash. |
| VGLA Receiver | In rear of engine compartment. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
