2000 Volvo C70 2D Convertible, 2.4 56FACTORY OEM SERVICE PROCEDURE

Checking control module communication: Verification

WARNING: This page is about a different car, the 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

HINT: After carrying out the repair check that the fault has been remedied. 

Fig 1: Identifying Ignition On Position
GLL101051Courtesy of VOLVO CARS OF NORTH AMERICA.
  • Ignition off.
  • Reconnect connectors, reinstall components.
  • Ignition on.
  • Volvo Scan Tool (ST) connected to data link connector (DLC).

    Power up the Volvo Scan Tool (ST) and try to establish communication with the ABS system.

    Fig 2: Identifying Scan Tool
    GLL100161Courtesy of VOLVO CARS OF NORTH AMERICA.

Is communication established? 

  • YES 

    OKAY:  Troubleshooting has been completed.

  • NO 

    Refer to Information 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.