Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Volvo S80 T-6FACTORY OEM SERVICE PROCEDURE
Vehicle Series Code - Position 8
The 8th number in VIN is the emissions code. Description is as follows:
- A (S70 & V70, Engine code 55)
Without EGR, without air pump, equipped with OBDII, with air-assisted fuel injectors, Denso engine management, Running Loss (RuLo) EVAP system, On-board Refueling Vapor Recovery (ORVR). - D (C70, S70, V70, Engine codes 53, 56, 62)
Without EGR, without air pump, equipped with OBDII, variable valve timing, Bosch ME 7.0 engine management, Running Loss (RuLo) EVAP system, On-board Refueling Vapor Recovery (ORVR). - D (S80, Engine code 90, 97)
Without EGR, without air pump, equipped with OBDII, variable valve timing, Bosch ME 7.0 engine management, Running Loss (RuLo) EVAP system, On-board Refueling Vapor Recovery (ORVR).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.