Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1999 Volvo S70 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Steering Column: Description
Steering column upper and lower sections are connected by a flange. On frontal impact, flange breaks from upper column. Upper column is supported by bearings in jacket tube or bearing housing.
WARNING:
Before performing any repairs, disconnect and shield negative battery cable from ground. Disconnect Yellow and Orange Supplemental Restraint System (SRS) connectors on driver's side of center console, near accelerator pedal, to avoid accidental air bag deployment. Follow air bag service precautions. See SERVICE PRECAUTIONS in AIR BAG RESTRAINT SYSTEM article in ACCESSORIES/SAFETY EQUIPMENT section. Disable SRS before removal.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.