1998 Volvo S70 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Link Rod

  1. Loosen throttle link lock nut so link is separated and can spring back easily to its innermost position. Mount link in position.
  2. Attach link end with ball and lock nut to throttle spindle. Ensure throttle spindle is in contact with adjusting screw "B" and pulley is seated against idle stop "C". Tighten throttle link lock nut "A". Rotate pulley to ensure link seats against adjusting screw "B" before pulley seats against idle stop "C". See Fig 1.
Fig 1: Adjusting Throttle Link Rod (C70, S70 & V70 Shown; S90 & V90 Are Similar)
G94D44159Courtesy of VOLVO CARS OF NORTH AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.