1998 Volvo C70 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

DTM 1 - Self-test: Notes

Fig 1: Identifying Number Of Times To Press Data Link Connector (DLC) Switch & Results
GLL125503Courtesy of VOLVO CARS OF NORTH AMERICA.

The microprocessor in the dashboard can store up to 7 different kinds of fault.

The control module has a memory for DTCs. This memory retains the DTCs even if the battery is disconnected for any length of time.

Use this DTM to find out if some input signals to the dashboard are missing or if the speed data signal leads are faulty. Speed data is something the dashboard sends to a large number of other systems, such as the trip computer, cruise control, fuel and ignition system and automatic gearbox.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.