Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Connecting the test box
- Ignition off
- Remove interior fuse 24 (11C/24)
- Loosen the combined instrument as described in Driver information module (DIM), replacing
- Release control unit connector.
Connect adapter 9511463 (22-16-14-pin) to control unit connector and connect test box 9511428 and wire 9511499 to adapter.
Alternatively connect test box 9813190 to adapter.
Disconnect the test box in the reverse order.
Additional information:Β
- To remove the combined instrument see Driver information module (DIM), replacing
- For information about signals and other values, see Driver Information Module (DIM) signal description .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
