Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Checking intake system: Remove/disconnect
- tool 9995545 and pressure regulator 9995544 from fresh air hose
- hoses from EVAP valve
- connector
- Connect hose from vacuum pump 9995843 to connection point under connector.
- Pump up vacuum
- Vacuum gauge should indicate steady value.
- If vacuum falls, replace EVAP valve.
Reinstall valve, hoses, soundproofing and connector on completion of check. Use clamp 9814215 and new hose clip, P/N 97 81 65-9, when installing.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.