1998 Volvo C70 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

TRACS switch

Fig 1: Identifying TRACS Switch And TRACS Warning Light
GLL126683Courtesy of VOLVO CARS OF NORTH AMERICA.

The TRACS switch (5) switches TRACS on and off (cars with TRACS only). Once the ignition is switched on, TRACS is on at all times. TRACS only disengages when the switch is pressed. The switch is spring-loaded and always returns to its normal position with the contacts broken.

The signal lead between the control module and TRACS switch is common to both the warning light and TRACS switch. The signal from the instrument panel (dashboard) warning light (4) to the control module is normally approx. battery voltage. When the switch is pressed, contact is made and the signal is grounded, causing the warning light to come on. The control module then disconnects TRACS and keeps the signal grounded, so the warning light stays on even when the switch is released.

The control module switches off the TRACS warning light on the instrument panel (dashboard) when TRACS is engaged via the switch.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.