1998 Volvo C70 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE

Brake light switch

Fig 1: Identifying Brake (Stop) Light Switch
GLL102208Courtesy of VOLVO CARS OF NORTH AMERICA.

The brake light switch sends a signal to the control module telling it that braking has started, so that the control module disengages TRACS, if it is in use, and stands by to use ABS/EBD if necessary, which means that the control module makes all calculations more precisely. If the control module does not receive any signals from the brake light switch, it will engage the ABS system, although the control will be rougher when ABS first cuts in.

The brake light switch is powered from the battery. When contact is made, the brake light switch comes on and the control module receives a signal telling it braking has started.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.