Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Volvo 850 AutomaticFACTORY OEM SERVICE PROCEDURE
Throttle Link Rod
- Mount link rod on throttle housing with "L" mark on rod at housing end and "R" mark on pulley end. Put a .10" (2.5 mm) feeler gauge at pulley stop. See Fig 1 . Turn middle of rod until clearance between lever and adjusting screw is .012" (.30 mm). Ensure rod does not turn and tighten lock nuts.
- Recheck clearance. Ensure a .020" (.50 mm) feeler gauge cannot be inserted between lever and adjusting screw. Ensure a .004" (.10 mm) feeler gauge can be inserted between lever and adjusting screw. If clearance is not correct, repeat step 1).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
