1993 Volvo 850 AutomaticFACTORY OEM SERVICE PROCEDURE

Basic Throttle Setting

NOTE: If basic throttle setting is adjusted, throttle position will change. Therefore, throttle switch must be adjusted whenever basic throttle setting is adjusted. See THROTTLE SWITCH under THROTTLE CONTROLSΒ  .

Loosen basic throttle setting adjustment screw lock nut. See Fig 1 . Turn screw until throttle is completely closed. Tighten adjustment screw until it touches throttle lever and then turn an additional 1/2 turn. On all models, tighten lock nut, making sure not to change adjustment. Recheck basic throttle setting.

Fig 1: Adjusting Basic Throttle Setting (240 Shown; 850 Similar)
G121537Courtesy of VOLVO CARS OF NORTH AMERICA.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.