Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Volvo 760 GLE, AW71LFACTORY OEM SERVICE PROCEDURE
Fuel Pump Circuit
- With fuel injection system relay removed, check for battery voltage at terminal No. 30. See Figure . If battery voltage is not present, repair wiring between relay connector and battery.
- Connect jumper wire between terminals No. 30 and 87/2 of fuel injection system relay connector. Fuel pumps should run. If not, check wiring between pump and relay. Also check wiring between terminals No. 87/1 and 85 for continuity. Repair as necessary.
NOTE:
ECU terminal identifications are marked on the unit or connector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.