Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Volvo 780 GLE, AW71FACTORY OEM SERVICE PROCEDURE
All Models
- Loosen basic throttle setting adjustment screw lock nut. See Fig 1 . Turn screw until throttle is completely closed.
- On 240 DL/GL, 740 GL & GLE models, tighten adjustment screw it touches throttle lever and then turn an additional 1/2 turn.
- On 740 Turbo, 760 GLE & 760 Turbo models, tighten adjustment screw it touches throttle lever and then turn an additional 1/4 turn.
- On all models, tighten locknut making sure not to change adjustment. Recheck basic throttle setting.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
