Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Volvo 760 GLE, AW71FACTORY OEM SERVICE PROCEDURE
Fuel Injectors
- Disconnect fuel injector connector. Using an ohmmeter, connect ohmmeter leads across fuel injector terminals.
- On 240 DL/GL, 740 GL, 740 GLE, and 760 GLE, ohmmeter should read 16 ohms resistance. On 740 GL ohmmeter should read 14 ohms resistance. On 740 Turbo and 760 Turbo, ohmmeter should read 3 ohms resistance.
- If fuel injector resistance is not according to specification, replace fuel injector.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.