Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1989 Volvo 760 GLE, AW71FACTORY OEM SERVICE PROCEDURE
Fuel Pump Circuit Test
- With fuel injection system relay removed, check for battery voltage at Terminal No. 30. If battery voltage is not present, repair wiring between relay connector and battery. See Figure .
- Connect jumper wire between terminals No. 30 and 87/2 of fuel pump relay connector. Fuel pumps should now run. If not, check wiring between pump and relay. Also check wiring between terminals No. 87/1 and 85 for continuity, repair as required.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
