1986 Volvo 245 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

If No Click Is Heard

Interchanged connector w/one that operates properly. If fault is trasferred to the "known-good" injector, this shows that the fault lies w/wiring. If original injector still does not function, it is probably defective. Mearsure injector resistance. Resistance should be 16 ohms at 20Β°C (68Β°F). Resistance increases as temperature rises.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.