Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
BOSCH LH-JETRONIC - Engine Control System: Description
The Volvo Computerized Engine Control System is used on Volvo 4-cylinder engines. It consists of a computer controlled electronic ignition system and Bosch LH-Jetronic 2.2 fuel system with integrated Constant Idle Speed system.
The computer controlled ignition system consists of Volvo breakerless distributor, an electronic control unit (ECU), ignition coil, ignition switch, throttle switch and knock sensor. The distributor contains no vacuum or centrifugal advance mechanisms. The rotor and armature are a single unit. See Fig 1 .
A Hall Effect sending unit in distributor provides engine speed signals to ECU. The distributor also consists of necessary connecting wiring and a distributor cap.
The fuel system includes an ECU, ignition coil, ignition switch, system relay, fuel system components, A/C switch, airflow meter, air control valve, starter motor, throttle switch, coolant temperature sensor, oxygen sensor and connecting wiring and hoses.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.