1986 Volvo 245 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Diesel Models

At high altitudes (above 4000 ft.), solenoid valve closes or engages and fuel pressure builds up between it and pressure control valve. As soon as pressure (acting on both sides of the valve) equalizes spring force, the altitude compensation valve closes slightly. This causes less fuel to be returned to pump inlet.

When less fuel is returned, pump pressure increases (which moves injection timer piston), and roller cage turns in the opposite direction to the cam disc. The disc them moves up onto cage earlier than usual (fuel injection takes place earlier).

At low altitudes (below 4000 ft.), solenoid valve is open or disengaged. Fuel is returned to pump inlet by means of 2 feedback channels; control valve and solenoid valve, and a channel beneath control valve.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.