Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1986 Volvo 244 Base, AutomaticFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Specification | |||||
|---|---|---|---|---|---|---|
| 240 Series | ||||||
| Front | ||||||
| Camber in Degrees | ||||||
| Fraction | 1/2 +/- 1/4 | |||||
| Decimal | .5 +/- .25 | |||||
| Caster in Degrees | ||||||
| Fraction | (1) | |||||
| Decimal | (1) | |||||
| Toe-In in Inches | ||||||
| Fraction | 1/16 +/- 3/64 | |||||
| Decimal | .06 +/- .05 | |||||
| Toe-In in Degrees | ||||||
| Fraction | 1/8 +/- 3/32 | |||||
| Decimal | .13 +/- .09 | |||||
| Toe-Out in Turns | ||||||
| Inner | (1) | |||||
| Outer | (1) | |||||
| Steering Axis Inclination (SAI) | (1) | |||||
| 740 & 760 Series | ||||||
| Front | ||||||
| Camber in Degrees | ||||||
| Fraction | (1) | |||||
| Decimal | (1) | |||||
| Caster in Degrees | ||||||
| Fraction | (1) | |||||
| Decimal | (1) | |||||
| Toe-In in Inches | ||||||
| Fraction | 3/32 +/- 1/32 | |||||
| Decimal | .09 +/- .03 | |||||
| Toe-In in Degrees | ||||||
| Fraction | 3/16 +/- 1/16 | |||||
| Decimal | .19 +/- .06 | |||||
| Toe-Out in Turns | ||||||
| Inner | (1) | |||||
| Outer | (1) | |||||
| Steering Axis Inclination (SAI) | (1) | |||||
|
||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
