1986 Volvo 244 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Gas Models

At high altitudes (above 4000 ft.), fuel supply is decreased in same proportion as air density. Normally, control pressure is regulated by a diaphragm and a spring. To achieve altitude compensation, another diaphragm with a spring and a chamber have been added. See Fig 1 .

Fig 1: Control Pressure Regulator with High Altitude Compensation
G40584

The chamber maintains a constant low altitude (below 4000 ft.) pressure while pressure outside it varies according to altitude. The pressure difference causes diaphragm to exert stronger or weaker pressure on inner spring.

At increasing altitudes, decreasing pressure outside diaphragm chamber causes lower diaphragm to rise. The resulting increase of pressure on upper diaphragm increases control pressure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.