1986 Volvo 244 Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Computer Controlled Ignition

As engine turns distributor shaft, shutter blades of rotor/armature assembly pass through Hall Effect sending unit's pick-up coil. A signal is then sent to the ECU.

In addition to receiving engine speed information from distributor, the ECU receives engine load information from intake manifold. Speed and vacuum signals are monitored by the ECU to control spark advance and dwell.

A throttle switch provides throttle information. Under normal conditions, throttle position signal is sent to the ECU.

The manifold vacuum signal is also processed by the control unit to control ignition timing. When throttle is closed, (during deceleration and idle) the circuit is closed, and no signal is sent to the ECU.

The ECU analyzes all information, and interrupts signal to ignition coil primary circuit. This causes a high voltage surge in secondary circuit, firing spark plugs at proper time.

The knock sensor detects engine detonation. The ECU receives a signal from the knock sensor during engine detonation and then retards timing. Timing is retarded 2Β° every 20 milliseconds until maximum retard of 6Β° is obtained, or detonation stops. Timing is then advanced in 1Β° increments every 20 milliseconds, until base timing is achieved or detonation begins again.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.