1983 Volvo 244 GLT, AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Valve Switch Adjustment

Open throttle valve slightly and listen to switch. A "click" (idle switch opens) should be heard immediately when throttle valve moves. To adjust the throttle valve switch (if required) follow the following procedure. Loosen switch screws with an inhex 3mm. Turn switch clockwise. Then turn switch counter-clockwise to stop, but not so far that throttle valve begins to open. Tighten screws. Check function.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.