Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1982 Volvo 264FACTORY OEM SERVICE PROCEDURE
Service Specifications
BELT ADJUSTMENT
| Application | (1) Deflection In. (mm) | ||
|---|---|---|---|
| Al1 Belts | .2-.4 (5-10) | ||
|
|||
REPLACEMENT INTERVALS
| Component | Miles |
|---|---|
| Oil Filter | 7500 |
| Air Filter | 30, 000 |
| Fuel Filter | 15, 000 |
| Fuel Tank Filter | 60, 000 |
| PCV Valve | 30, 000 |
| Spark Plugs | 30, 000 |
| Oxygen Sensor | 30, 000 |
FLUID CAPACITIES
| Application | Quantity |
|---|---|
| Crankcase (Including Filter) | 4.0 qts. (3.8L) |
| Cooling System (Including Heater) | 10.0 qts. (9.4L) |
| Auto. Trans. (ATF Type F) | 14.6 pts. (6.9L) |
| Rear Axle (SAE 90) | 3.4 pts. (1.6L) |
| Fuel Tank | 15.8 gals. (60.0L) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.