Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Cruise Control Switch
Unplug connector at cruise control switch. Connect a jumper wire from battery voltage to Red wire in connector. Connect a test lamp to ground, then touch it to the other 3 wires while checking switch operation. See Cruise Control Switch Continuity table .
| Switch Position | Brown | Green | Yellow |
|---|---|---|---|
| OFF | on | off | off |
| ON | on | on | off |
| ON & SET SPEED | on | off | on |
| RESUME | on | on | on |
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.