Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1980 Volvo 245 Automatic TransFACTORY OEM SERVICE PROCEDURE
Air/Fuel Mixture Control (Air Flow Sensor)
- Remove rubber bellows to expose plate in sensor. Disconnect electrical connectors on auxiliary air valve and control pressure regulator, then operate fuel pump for ten seconds to build up control pressure.NOTE: Directions given for moving sensor plate apply to engines where sensor plate moves UP with air flow. Reverse directions if servicing an engine where air flow moves DOWN.
- Lift sensor plate slowly with magnet or pliers. Resistance due to control pressure should be constant throughout range of plate. Release plate slowly, lever and control piston should follow.
- Lift plate, then return it rapidly to lower position. The piston moves more slowly and should be heard hitting the lever. If not, control piston is sticking. Remove 3 screws from fuel distributor and lift off of air flow sensor housing. Be careful not to drop control piston.
- Clean plunger in gasoline. Remove any deposits with finger nail; DO NOT use tools. Slide plunger in and out while turning it. If any sticking or binding is felt, replace fuel distributor.
- Reinstall fuel distributor. Check air flow sensor plate alignment. Plate should be even with bottom rim or 0.02" (0.5 mm) lower. If not, bend spring to correct, or reposition stop pin (tap lightly with punch).
- Plate should be centered in housing. If not, loosen center screw and align plate with 0.004" (0.1 mm) feeler gauge at four points around rim. Apply Loctite and tighten screw.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
