Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1974 Volvo 142 Automatic TransFACTORY OEM SERVICE PROCEDURE
All Models
Place wheels in straight-ahead position and loosen lock nuts on steering links (tie rods). To adjust toe-in, rotate adjustable sleeves until correct toe-in is obtained. Tighten lock nuts and recheck toe-in.
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Caster (Degrees) | Camber (Degrees) | Toe-In (Inches) | Toe-Out On Turns (Degrees) | |
|---|---|---|---|---|---|
| Inner | Outer | ||||
| All Models | 1 1/2Β±1/2 | 1/4Β±1/4 | 1/8 | ..... | ..... |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
