Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Tire Pressure Monitoring System, Calibrating
The tire pressure monitoring system should always be calibrated only "after" the tire pressure values have been adjusted to the correct values.
If no pressure loss and no tire damage can be found after a tire pressure warning, the erroneous warning can be eliminated by calibrating.
Using the ABS speed sensors, the tire pressure monitoring system compares the RPM, the tire tread circumference and the vibration behavior of the individual wheels. The tire pressure monitoring system displays tire pressure changes in one or more wheels in the instrument cluster and in the Infotainment system.
The tire tread circumference changes when:
- The tire pressure is too low.
- Tires have structural damage.
- Vehicle is loaded on one side.
- Wheels of one axle are loaded higher, for example, when towing trailer or driving uphill and downhill.
- Snow chains are installed.
- The emergency wheel is installed.
- One wheel per axle was replaced.
The yellow Tire Pressure Monitoring Display Indicator Lamp -- is inside the instrument cluster -arrow-.
- A "STEADY LIGHT" with a warning tone indicates "WARNING", a loss of pressure was detected, check the tire pressure, and perform calibration.
Calibration
-- Switch the ignition on.
-- Switch on the Infotainment system.
-- Personalization: Select the user by selecting OK .
-- Tap the Vehicle function button.
-- Select Status
-- Select Status (on top)
-- Navigate to the last menu.
-- Select Set on the screen.
-- Confirm the tire pressures by selecting Confirm .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
