2025 Volkswagen Golf R BaseFACTORY OEM SERVICE PROCEDURE

Quick Lookups: Fluids

FLUID CAPACITIES
Fluid Type Application Standard Metric Fluid Spec Note S/H
Air Cond Compressor Oil Denso 2.90 OZS. 0.08 L S
Air Cond Compressor Oil Mahle 3.85 OZS. 0.11 L S
Air Cond Compressor Oil Sanden 2.70 OZS. 0.07 L S
Air Cond Refrigerant 1.05 LBS. 0.47 KG R-1234yf Approximate capacity. S
Automatic Transmission Fluid Initial Fill 7.20 QTS. 6.81 L VOLKSWAGEN Automatic Transmission Fluid G 055 529 A2 Part numbers are for reference only. Approximate capacity. S
Automatic Transmission Fluid Refill 6.40 QTS. 6.05 L VOLKSWAGEN Automatic Transmission Fluid G 055 529 A2 Part numbers are for reference only. Approximate capacity. S
Brake Fluid Hydraulic Fluid 1.30 QTS. 1.23 L Part No. B 000 750 M3. Part numbers are for reference only. S
Differential Gear Oil Front Axle,Differential Lock,Initial Fill 0.64 QTS. 0.6 L S
Differential Gear Oil Front Axle,Differential Lock,Refill 0.42 QTS. 0.39 L S
Differential Gear Oil Rear Final Drive,Torque Splitter,Clutch Cable 0.85 QTS. 0.8 L 4.25 qts. on each side. Housing lettering "Clutch Oil". Approximate capacity. S
Differential Gear Oil Rear Final Drive,Torque Splitter,Hypoid Chamber 0.60 QTS. 0.56 L Housing lettering "HYPOID Oil." Approximate capacity. S
Engine Coolant 10.50 QTS. 9.93 L Approximate capacity. S
Engine Oil w/Filter 6.00 QTS. 5.67 L VW 504 00 SAE 0W-30 S
Transfer Case Fluid Bevel Box 1.00 QTS. 0.94 L Approximate capacity. Fill for-life. S
Windshield Washer Fluid 4.50 QTS. 4.25 L Part No. G 052 164 M2. Part numbers are for reference only. S
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.