2019 Volkswagen Arteon SEL PremiumFACTORY OEM SERVICE PROCEDURE

Lane Change Assistance Control Module - J769-/Lane Change Assistance Control Module 2 - J770-, Removing and Installing: Removing: Notes

  • Remove the rear bumper cover. Refer to Rear Bumper; Bumper Cover, Removing and Installing.
  • Release the retaining tabs -3- on the shield -1-. -->
  • Remove the shield -1- from the bracket -2- toward the rear.
  • Release and disconnect the connector -7-.
  • Release the retainer -5- from the bracket in the direction of -arrow A-.
  • Pivot the lane change assistance control module -4- in direction of -arrow B- out of the bracket -6- and remove.
    G12617247Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
  • Remove the bracket -2- for the wire -3- from the bracket -1-.
  • Remove the nut -4-.
  • Release the retainer -arrow A- from the bracket -1-.
  • Pivot the bracket -1- in the direction of -arrow B- out of the retainer on the body and remove.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.