Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2018 Volkswagen Passat R-LineFACTORY OEM SERVICE PROCEDURE
Engine System (Diagnostic Procedures - DDSA, DDSB)
- St Generic Scan Tool
- Diagnosis And Testing
- Notes
- Diagnostic Procedures
- Notes
- Accelerator Pedal Module - GX2-, Checking
- Cam Actuators --, Checking
- Camshaft Adjustment Valve 1 - N205-, Checking
- Camshaft Position Sensor - G40-, Checking
- Camshaft Position Sensor 3 - G300-, Checking
- Can-Bus Terminal Resistance, Checking
- Can-Bus Terminal Resistance, Powertrain, Checking
- Charge Air Pressure Actuator - V465-, Checking
- Charge Air Pressure Sensor - G31-, Checking
- Coolant Shut-Off Valve - N82-, Checking
- Engine Coolant Temperature Sensor - G62-, Checking
- Engine Coolant Temperature Sensor On Radiator Outlet - G83-, Checking
- Engine Speed Sensor - G28-, Checking
- Engine Temperature Control Module - GX33-, Checking
- EVAP Canister Purge Regulator Valve 1 - N80-, Checking
- Exhaust Camshaft Adjustment Valve 1 - N318-, Checking
- Fuel Delivery Unit -GX1- / Fuel Pump Control Module -J538-, Testing
- Fuel Injectors --, Checking
- Fuel Pressure Regulator Valve -N276-, Checking
- Fuel Pressure Sensor -G247-, Checking
- Fuel Tank Leak Detection Control Module - J909-, Checking
- Heater Support Pump - V488-, Checking
- Ignition Coils With Power Output Stage --, Checking
- Intake Manifold Runner Control Valve - N316-, Checking
- Intake Manifold Runner Position Sensor - G336-, Checking
- Intake Manifold Sensor - GX9-, Checking
- Knock Sensor 1 - G61-, Checking
- Mass Airflow Sensor - G70-, Checking
- MOTRONIC Engine Control Module Power Supply Relay - J271-, Checking
- Outside Air Temperature Sensor - G17-, Checking
- Oxygen Sensor 1 After Catalytic Converter -GX7-, Checking
- Oxygen Sensor 1 Before Catalytic Converter -GX10-, Checking
- Secondary Air Injection Pump Relay - J299- / Secondary Air Injection Pump Motor - V101-, Checking
- Secondary Air Injection Sensor 1 - G609-, Checking
- Secondary Air Injection Solenoid Valve - N112-, Checking
- Three Way Catalytic Converter, TWC Checking
- Throttle Valve Control Module - GX3-, Checking
- Transmission Coolant Valve - N488-, Checking
- Turbocharger RECIRCULATION Valve - N249-, Checking
- Vehicle Speed Signal, Checking
- Diagnosis And Testing
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.