Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Volkswagen e-Golf SEFACTORY OEM SERVICE PROCEDURE
General Information
- General Information
- Engine Overview
- Service Work
- Fixed Service Information
- Maintenance Tables
- Notes
- Pre-Delivery Inspection
- Services
- Service Intervals
- Air Filter
- Dust And Pollen Filter
- Panorama Sliding Sunroof
- Front Sunroof Water Drains And Rear Water Drain Valves
- Toothed Belt
- Ribbed Belt
- Diesel Fuel Filter
- Spark Plugs
- Brake Fluid
- Natural Gas System
- Automatic Transmission
- Additional Procedures Dependent On Time And Mileage
- General Information
- High-Voltage System General Warnings
- Vehicle, Raising With Hoist Or Workshop Vehicle Jack
- Maintenance Schedule Entries
- Severe Operating Conditions
- Vehicle Diagnostic Tester
- Vehicle Identification Number (VIN)
- Vehicle Data Label
- Hot Climate Countries
- Country Overview For Gasoline, That Does Not Meet Standard En 228
- Engine Code And Engine Number
- Type Plate
- Procedure Descriptions
- Notes
- Ball Joints And Axle Bearing, Visually Inspecting
- Automatic Headlamp Control And Stationary Cornering Lamp, Checking Function
- Automatic Transmission 09G, Changing ATF
- 12V Battery, Checking Battery Terminal Clamp For Secure Seating
- 12V Battery, Checking Using Battery Tester (Always Follow Service Information)
- 12V Battery Charge, Reading And Sending Diagnostic Log Online
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.