Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Remove The Amplifier -R12
-- Raise the front seat into its highest position and then move it all the way back.
-- Turn off the ignition and all electrical equipment.
-- If equipped remove the ignition key.
-- Unlock the rear left and right cover -1- in direction of -arrow A-.
-- Pull the cover forward -1- in direction of -arrow B-.
-- Remove the bolts -4- from the Amplifier -R12- -2-.
-- Pull the Amplifier -R12- -2- out just enough until the connector -3- is accessible.
-- Release and disconnect the connector -3- from the Amplifier -R12- -2-.
-- Remove the Amplifier -R12- -2- completely.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.