Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Volkswagen Golf S, 2D Hatchback, Eng CD CXBA, Automatic TransFACTORY OEM SERVICE PROCEDURE
Side Object Detection Module: Remove & Replace
WARNING: This page is about the Golf Base, Eng CD CXBA, Automatic Trans, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both Sides,J1086/J1087 | DOES NOT include Calibration. | 0.8 | B | |
| One Side,J1086/J1087 | DOES NOT include Calibration. | 0.5 | B | |
| Combination Procedure: SIDE OBJECT DETECTION MODULE: Calibrate: | ||||
| The blind spot detection calibration normally occurs automatically.Static calibration is only required when there is a DTC memory entry. Static calibration is only required when there is a DTC memory entry. Includes: Additional time for use of scan tool to perform this procedure. | 1.0 | B | ||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.