Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2016 Volkswagen Golf R Standard TransFACTORY OEM SERVICE PROCEDURE
Side Object Detection Module: Remove & Replace
WARNING: This page is about the Golf R Automatic DCT Trans, which is a different variant/trim than selected.
| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| Both Sides,J1086/J1087 | DOES NOT include calibration. Note: Calibration normally occurs automatically with replacement. Static calibration is only required when there is a DTC memory entry. | 0.8 | B | |
| One Side,J1086/J1087 | DOES NOT include calibration. Note: Calibration normally occurs automatically with replacement. Static calibration is only required when there is a DTC memory entry. | 0.5 | B |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.