2007 Volkswagen Passat 3.6, 4D SedanFACTORY OEM SERVICE PROCEDURE

Climatronic Control Module Connector End View (J255, T16i)

Fig 1: Climatronic Control Module Connector End View (J255, T16i)
G10539253Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Cavity Function
1 5 volt sensor, output
2 Left temperature door potentiometer/actuator, sensor input (5V=warm)
3 Right temperature door potentiometer/actuator, sensor input (5v = warm)
4 Defroster door motor position sensor, sensor input (5v = defrost)
5 Front air distribution door motor position sensor, sensor input (5v = instrument panel)
6 --
7 Signal, fresh air/recirculating air/back pressure door motor position sensor
8 Signal, left footwell vent temperature sensor
9 Signal, right footwell vent temperature sensor
10 --
11 Signal, Evaporator temperature sensor
12 --
13 --
14 Signal ground
15 --
16 --
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.