2007 Volkswagen Eos 3.2FACTORY OEM SERVICE PROCEDURE

Diagnostic Mode, Selecting: Notes

Selectable diagnostic modes
Diagnostic Mode 01 - Obtain Data DIAGNOSTIC MODE 01 - READ CURRENT SYSTEM DATA .
Diagnostic Mode 02 - Obtain Operating Conditions DIAGNOSTIC MODE 02 - READ OPERATING CONDITIONS .
Diagnostic Mode 03 - Interrogating Fault Memory DIAGNOSTIC MODE 03 - READ DTC MEMORY .
Diagnostic Mode 04 - Reset/Delete Diagnostic Data DIAGNOSTIC MODE 04 - ERASE DTC MEMORY .
Diagnostic Mode 06 - Check Test Results of Components that are not Continuously Monitored DIAGNOSTIC MODE 06 - READ TEST RESULTS FOR SPECIFIC DIAGNOSTIC FUNCTIONS .
Diagnostic Mode 07 - Check Test Results of Components that are Continuously Monitored DIAGNOSTIC MODE 07 - READ FAULTS DETECTED DURING THE CURRENT OR LAST DRIVING CYCLE .
Diagnostic Mode 08 - Tank Leak Test DIAGNOSTIC MODE 08 - REQUEST CONTROL OF ON-BOARD SYSTEM, TEST OR COMPONENT .
Diagnostic Mode 09 - Vehicle Information DIAGNOSTIC MODE 09 - READ VEHICLE INFORMATION .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.