Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Volkswagen Eurovan V6-2.8L (AXK)FACTORY OEM SERVICE PROCEDURE
Automatic Transmission Control Module (TCM) -J217
automatic transmission control module (TCM) -J217
Fig. 4 Location of automatic transmission control module (TCM) -J217-
The control module is located in the left footwell, on the "A" pillar.
If the engine or transmission control module is replaced, the system must be reset.
Fig. 5 Removing and installing automatic transmission control module (TCM) -217
^ Remove relay plate cover and unhook relay plate.
^ Switch ignition off, release multi-pin connector in direction of arrow and pull out of control module.
^ Remove control module.
Installation is performed in the reverse order.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.