2003 Volkswagen Eurovan V6-2.8L (AXK)FACTORY OEM SERVICE PROCEDURE

Vehicle Speed Sensor: Service and Repair



Factory service manual diagram




Fig. 15 Vehicle speed sensor (VSS) -G68-
Location: The vehicle speed sensor is located on front of transmission.

Removing and installing vehicle speed sensor
^ Pull black connector off sensor.
^ Remove bolt and pull sender out.
^ Always replace O-ring.

Installation is performed in the reverse order.
^ Tighten bolt to tightening torque - 10 Nm
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.